Cloudmylab KnowledgeBase
            Knowledge Base Cloudmylab CCIE Routing and Switching LAB ACCESS GUIDE

            CCIERS V5 Lab Access Guide

            Getting Access to the POD

             

            1. There are two methods you can get access to the access detail as mentioned below:
            2. Login with the credentials provided


            1. Once you login you will see a customized Desktop from where you can access all the devices

            How to reset the lab

            Reset devices inside EVE-NG topology:

            1. Make sure you first turn off all the devices inside the EVE-NG topology. To turn off, hover your mouse on the sidebar and click on More Actions Stop all nodes.

            2. Wipe all the nodes to bring them back to the base configuration. Hover your mouse on the sidebar and click on More Actions Wipe all nodes.

            3. When prompted, click Yes.

            How to start/restart EVE-NG VM

             

            Once you get the access to the Guest Desktop Environment

            1. Open Firefox, you will see following bookmarks
              • Restart Server
              • EVE | Login

            2. Click on "Restart Server" bookmark.
            3. Click on "Restart" button.

            4. After that, you will get the following screen with 45 seconds countdown timer. Please be patient and wait for the timer to expire.(Do not reload the page)

            5. After the timer expires, following screen will appear. Click on "Click here" button to proceed.

            6. You will see the following window. 
              • EVE-NG server address: Provided as the bookmark
              • Username: admin
              • Password: eve

            7. Select the lab from the list

            8. Once you click on the required lab, a preview opens up on the right side of the page.

            9. Click on the Open button at the bottom of the preview. You will be redirected to the lab.
            10. To start the nodes, hover the mouse on the left sidebar then click on More action > Start all nodes. Wait for all the nodes to turn blue.

            11. Hover the mouse again over the sidebar and click on Pictures which will open up a dialog box. Click on the text inside the dialog box to open the topology.
            12. Click on the devices inside the topology to open their session.

            How to stop the Lab

             

            1. Hover your mouse over the sidebar and click on More actions > Stop all nodes.

            2. Hover your mouse over the sidebar and click on the Close lab.

            Updated: 22 May 2018 12:31 AM
            Helpful?  
            Help us to make this article better
            1 0