How to Install Palo Alto on EVE-NG

Once you connected to WinSCP. The column on the left represent file on local machine and the column on the right represent files and folder on remote machine.

Step 1: Log in with the given credentials.

Step 2: Go to the path opt->unetlab->addons->qemu on the remote machine

Step 3: Navigate to the folder from local to remote machine and upload.

Step 4: Once the process completed the file will be available immediately.

Step 5: Open the EVE-NG in the browser then ‘add an object’ and select the Node.

Step 6: Add PA-VM Node and Start the nodes.

Step 7:  Start PA-VM node.

Default username is admin and password is admin.

Step 8: Assign IP to the PA-VM node.

Commands:

#set deviceconfigure system type static

#set deviceconfigure system ip-address 192.168.190.44 netmask 255.255.255.0 default-gateway 192.168.190.1

 #commit

Step 9: Verify its IP address by command:

>show system info

Step 10: Login to Win with username: user and password: Test123 and assign IP address to Windows.

Step 11: Now we can manage the PA-VM node via GUI default username is admin and password is admin

• Related Articles

• Setup Palo Alto Management IP using Cli

  This document describes how to configure the Management Interface IP on a Palo Alto Networks device. Steps CLI: Note: Hook up a Palo Alto Networks console cable to a Palo Alto Networks device first.   Login to the device with admin/admin, unless you ...

• Do you provide IOU/IOL for EVE-NG Hosted Service?

  No. However, if you have the image, you can upload it yourself after you sign Liability Waiver form

• How to make the Cisco Access Points work with Hosted EVE-NG on Cloudmylab platform

      Purpose The purpose of this document is to help cloudmylab Customers and partners to set up a base Cisco Wireless Lab   Pre-Requisites 1.       WLC version 8.5.X 2.       AP version 15.3.3 JF 1 or higher 3.       AP 3502i   Refer to the WLC ...

• EVE-NG OOB ACCESS ( Use of Cloud1 network)

  EVE-NG OOB ACCESS ( Use of Cloud1 network) Introduction   Preface This document outlines how to access and use the devices over Cloud1 for out-of-band management in EVE-NG on Cloud My Lab infrastructure. Audience This document is intended for use by ...

• Setting up Nexus 9000v with Username and Password

  Premise: This article Focuses on setting up the username and password on Cisco Nexus 9000v This Article Applies to All the Subscribers using GNS3,VIRL, EVE/ESXI 1. Once the device is booted up ) It can take up to 5 mins for the device to completely ...