How to add Appliance and Image on GNS3
Step 1: Click
on “browse all devices” then select “new appliance template button”.
Step 2: Select “import an appliance template file”.
Step 3:
Select the appliance file. Then click next.
Step 4: Select
over the existing file and then click on the download option.
Step 5:
Once you click the download option it redirects you over this web page. Then
download the image.
Step
6: Create the version of
the downloaded file then
click over the import option.
Step
7: Select the downloaded image file from the folder.
Step 8: Once
the file is imported successfully select
next.
Step 9: Finally,
you can see the image in the installed appliance tab.
Related Articles
Can you add physical devices on my lab instance once I subscribe?
Yes, we can add physical devices to your lab instance at a cost. Example- 3500 series access points at $10 a month, CISCO 3750x switches at $100/Month, ASA 5512 at $150 a month, etc
Setting up Nexus 9000v with Username and Password
Premise: This article Focuses on setting up the username and password on Cisco Nexus 9000v This Article Applies to All the Subscribers using GNS3,VIRL, EVE/ESXI 1. Once the device is booted up ) It can take up to 5 mins for the device to completely ...
Ready to Download Linux Images
Due to very high demand of this section and problems with how to create Linux images under EVE, we are offering ready to go and prepared Linux image pack. You can choose any of Linux image from the pack below and simply upload into EVE. Download your ...
Do you provide IOU/IOL for EVE-NG Hosted Service?
No. However, if you have the image, you can upload it yourself after you sign Liability Waiver form
How to Configure pfSense on EVE-NG
Step 1: Open the EVE-NG in the browser then ‘add an object’ and select the Node. Step 2: Add pfSense Node and Start the nodes.